Pneumatic hydraulic pump high pressure on sale for metallurgy Suncenter

Company Advantages
1. High-efficiency production: Suncenter air over hydraulic pump is well manufactured. Every detail of this product is paid close attention and it is brought out with the fine quality and performance.
2. Internationally-certified quality: The product, tested by the authoritative third-party, has been approved to meet with the widely-recognized international quality standards.
3. Durability: It has been given a relatively long lifespan and can retain somewhat functionality and aesthetics after long-time application.
4. The point of Dongguan Suncenter Fluid Control Equipment Co., Ltd is to ensure pneumatic hydraulic pump high pressure, rather than air operated hydraulic pump .
5. pneumatic hydraulic pump high pressure is perceived as air operated hydraulic pump with high commercial value.

We offer the most complete range of Air driven liquid pump models in the industry measured for:

SUNCENTER pumps are air driven at a drive air pressure of 1bar to 8bar (14.5 psi to116 psi) by the normal air compressor. Basically the principle of operation is similar to a reciprocating amplifier where control of the piston at the end position is regulated by a pilot operated 4/2 way valve.

Suncenter pumps feature a large air piston joint to a smaller diameter plunger. The pressure ratio is the difference of these two areas and is the method of determining maximum outlet pressure. Higher pressures obtained by using higher pressure ratios.Suncenter model numbers reflect the pumps nominal pressure ratios， while the technical data indicates exact ratios. The outlet pressure is easily to set through a simple air regulator. By multiplying the pressure ratio by the available shop air pressure, the nominal liquid pressure can be calculated.

SUNCENTER pumps are self priming. In general it is not necessary to use an air line lubricator. The liquid to be pumped flows into the suction chamber by the up-stroke of the drive piston. By this suction effect, the inlet check valve is opened and the outlet check valve is closed. The down-stroke generates the pressure at the liquid side. The inlet check valve is closed and the outlet check valve is opened by the generated pressure. SUNCENTER liquid pumps cycle automatically, where the pressure is built up the numbers of cycles slow down, the pump stops automatically when the output pressure forces are equal. The pump restarts with a slight drop in the outlet pressure or an increase in the air drive pressure. Pump performance can be affected by a number of conditions, such as freezing of muffler or pilot valves (which is caused by moisture in air lines), inadequate inlet air line sizes and dirty filers. Don’t reduce the indicated port sizes and consult SUNCENTER for exact flow conditions not shown in charts.

Company Features
1. Dongguan Suncenter Fluid Control Equipment Co., Ltd has a dominant market share in China's air over hydraulic pump industry.
2. Through the pneumatic hydraulic pump high pressure technology, air driven liquid pump is produced to be of high quality.
3. Our commitment to our customers has been at the core of who we are. We're committed to constantly creating and reinventing with the singular purpose of making a real difference for our customers. We strictly abide by environmental obligations. During our production, we ensure that our use of energy, raw material, and natural resources are totally legal and environmentally friendly. Since the inception till now, we have been adhering to the principle of integrity. We always conduct business trade in accordance with fair and refuse any vicious business competition. We aim to reduce the negative impact on environmental. We constantly adopt new production technology and energy-saving technology to minimize emission.